PE drinking-water pump cable 4G2.5 with blue PE sheath and four fine-stranded copper cores

Submersible Pump Cables TEBAOFLEX

PE Drinking Water Pump Cable 450/750 V

PE drinking-water pump cable is a 450/750 V flexible, double-insulated lead for submersible water pumps. Both the core insulation and the blue outer sheath are polyethylene, with Class 5 copper conductors.

450/750 V
PE core insulation and a blue PE outer sheath
Plain flexible copper, Class 5
−20 to +70 °C, flexible use

Send the configuration, motor or controller drawing, installed length and entry dimensions for a technical quotation.

Product information

Category: Submersible Pump Cables
Brand: TEBAOFLEX

Product overview

PE drinking-water pump cable for Pump Connections

Select the three-core or four-core construction from the motor wiring diagram before choosing the conductor cross-section. The G designation includes a green/yellow protective conductor. The configuration table keeps the minimum and maximum outside diameters with the approximate mass, so the cable entry can be checked against the actual sealing range rather than a nominal conductor size alone.

The compact 1.5 mm² and 2.5 mm² configurations suit small pump connections where cable clearance and flexible handling matter. Motor current, starting conditions and installed length still determine the electrical selection. Account for the complete water-contact route, including joints, entry sleeves and accessories, when specifying a drinking-water installation.

Support the cable independently along the pipe or riser and allow a smooth transition into the pump entry. Mechanical lifting belongs to the pump lifting system. Include the water composition and applicable drinking-water documentation with the enquiry; immersion depth and the permitted water-temperature limit are confirmed for the project.

Match 3G or 4G to the motor circuit and protective-earth requirement.
Use the listed diameter limits when selecting the entry seal.
Distinguish this all-PE insulation/sheath system from a PVC-insulated cable with a PE sheath.

Selection resources: submersible pump cable range · rubber and PVC cable guide.

Construction

PE core insulation and a blue PE outer sheath. The representative image follows the selected configuration; other sizes retain their stated core arrangement.

PE drinking-water pump cable layer schedule
Layer	Construction
Conductor	Plain fine-stranded copper, Class 5 to IEC 60228.
Core insulation	Polyethylene on each conductor.
Core arrangement	Round 3G or 4G assembly with a green/yellow protective conductor.
Outer sheath	Blue polyethylene. No metallic screen or armour.

Applications

PE drinking-water pump cable selection checkpoints
Selection point	What to coordinate
Motor connection	Select core count from the motor terminal diagram, including protective earth.
Circular entry	Match the complete minimum-to-maximum OD range to the seal and cable gland.
Route support	Use independent cable supports; the electrical lead must not support the pump.
Material choice	PE insulation plus PE sheath differs from PVC insulation plus a PE sheath.

Confirm immersion depth and the maximum permitted water temperature with the enquiry. Support the cable independently; use a separate mechanical system to lift the pump.

Specifications

Keep the exact configuration and its installation conditions together when selecting the cable entry and route.

PE drinking-water pump cable technical parameters
Parameter	Value
Rated voltage U₀/U	450/750 V
Conductor	Plain flexible copper, Class 5
Insulation and sheath	PE core insulation and a blue PE outer sheath
Temperature condition	−20 to +70 °C, flexible use
Installation profile	Round
Protective conductor	G: green/yellow core included
Available sections	1.5 mm² and 2.5 mm²
Available core counts	3 and 4